![]() Press F10 to save the configuration, system will reboot to save the changes.Running the below commands will create an ISO on your desktop named HighSierra.iso: hdiutil create -o /tmp/HighSierra.cdr -size 5200m -layout SPUD -fs HFS+J hdiutil attach /tmp/ -noverify -mountpoint. Here is the option to change the boot priority. Next, you need to create an ISO from the installer application that was downloaded in step 1.Press enter and select the required boot option.Change the boot order by going to Boot option #1 or any other according to requirement.Go to “boot options” using right arrow key.Here Is the snippet of desired boot order however we won’t be able to change this from CIMC ![]() But if you facing an issue where server falls into the SHELL> prompt you will see first boot order shall be Internal EFI shell which you need to change the boot order from bios. Here we can see the Actual boot order is “HDD then FDD and so on. Either you can check through CIMC or directly taking console of the server. Solution: You need to verify what boot priority is set on the server. ![]() In that case you have to manually take console or through CIMC (KVM). Due to this it causes a problem where VSM application does not load by default when there is any power outage or system restart. SHELL> Exit (Enter) it will load the VSM application and take you to the bash prompt of VSM. PCI RAID adapter however in order to boot the server from PCI adapter i.e. We have seen issue where UCS while booting up it stuck in Shell> prompt.when Cisco Sends Bare metal UCS server loaded with VSM application, It sometimes gets it stuck in SHELL>(Prompt) which will not let you boot from the
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |